Nexans Euromold 400AR-4BC Equipment Bushing
Nexans Euromold 400AR-4BC Equipment Bushing

Product overview

Nexans Euromold 400AR-4BC Equipment Bushing

Nexans Euromold 400AR-4BC/ K400AR-4BC Equipment Bushings are MV-HV Bushings for use in equipment insulated with air, typically for switchgear, capacitors, motors that are specified to terminate and connect medium/high voltage cables in the following voltage classes:

  • 6/10 (12kV)
  • 6.35/11 (12kV)
  • 8.7/15 (17.5kV)
  • 12/20 (24kV)
  • 12.7/22 (24kV)

Part Numbers:
703937 – K400AR-4BC/J + KBC-RING CLAMP 3 *SS
703939 – K400AR-4BC/J-ATEX-IECEx + KBC-RING CLAMP 3 *SS

Technical Characteristics

  • Each bushing is tested for AC withstand and partial discharge prior to leaving the factory.
  • The bolted type equipment bushings are moulded epoxy insulated parts and meet the requirements of CENELEC EN 50180.
  • A non-tracking insulating rubber boot is installed over the bushing shank.
  • On the new Interface C in-air bushing you can install all separable connectors of the Interface C product family. It also offers the possibility to install a Surge Arrester.
  • The new Interface C in-air bushing is also available with ATEX/IECEx/UKEx certification.

Specification & Design

To order the equipment bushing, specify the type. The bushings can be supplied with an earth jumper (/J) or an earth plate (/GS). This earth connection must be specified when ordering (e.g. K400AR-4BC/J):

Euromold Equipment
Bushing Type		 Voltage
Um		 Current
Ir		 Creepage Length
A-B
400AR-4BC 12 kV 1250 Amps 315 mm
K400AR-4BC 24 kV 1250 Amps 315 mm

 

Note: For dimensions of the above bushing types, refer to the Technical Data Table below.

Nexans Euromold 400AR-4BC Fixings for Bushings

400AR-4BC Fixings

For Ordering Instructions and Part Number Selection Table of Nexans Euromold 400AR-4BC/ K400AR-4BC Equipment Bushings, please refer to the Technical Data Table Below. For additional General and Technical Information, download PDF File.

FREE Technical Advisory Service
E-Tech Components UK Ltd maintains a free technical advisory service.
Contact us for enquiries concerning this and all other products: +44 (0) 1744 762 929

Technical Data

ORDERING INSTRUCTIONS

To order the equipment bushing, specify the type. The bushings are supplied with an earth jumper (/J) or an earth plate (/GS).

This earth connection must be specified when ordering (e.g. K400AR-4BC/J).

For use in potentially explosive atmospheres (for 12kV max), order -/ATEX

euromold 400AR4-4BC Design
EQUIPMENT BUSHING TYPE VOLTAGE
Um		 CURRENT
Ir		 A B C D E Dia. F Dia. G Dia. H
400AR-4BC 12 kV 1250 Amps 329 mm 138 mm 36 mm M16 40 mm 100 mm 150 mm 32 mm
K400AR-4BC 24 kV 1250 Amps 329 mm 138 mm 36 mm M16 40 mm 100 mm 150 mm 32 mm

Find out more about our products or becoming a supplier